JE-MA T35

THREE-IN-ONE GRAIN CONVEYOR


The JE-MA T35 "three in one" grain conveyor isdesigned to transport grain either vertically or horizontally andfill or empty horizontally and to fill or empty the store withthe use of only one drive station. The unit is assembled by usinga series of square tubes available in various lengths, which areconnected together by corner sections.
The grain is transported throughout the system by means of aheavy duty roller chain with rubber flights, as used on the T20and T60 elevators. Any number of inlets and outlets can be fittedinto any position along the horizontal conveying section.

The motor is fitted onto a standard motor bracket which isfitted to the return section. The drive is transmitted from themotor to the conveyor by V-belts.

The inlet trough(s) on the lower conveyor introduces graininto the system and can be supplied in varying lengths from 0.5mto 2.0m to suit any installation.

Disc springs are fitted on the threaded spindles on thetightening section to provide ample adjustment. These springsalso provide a safety factor by allowing foreign objects of areasonable size fall through the chain and sprocket withoutcausing damage and then to the original tension.

  1. Drive station
  2. Tightening section
  3. Corner section
  4. V-belt pulley drive
  5. conveying section
  6. inlet trough
  7. Return section
  8. Outlet
  9. Connecting conveying section/inlet through

Inside each inlet trough, a cover is provided to give an evenfeed and to reduce any excess weight on the conveying chain bythe incoming grain.

When the T35 is employed for emptying a floor drying plant,the inlet trough is placed in a trench in the ground. The trenchis covered with short timber or steel covers, which are made insuch a way, that they easily remove. To empty the plant thesecovers are gradually removed one after another concurrently withthe grain running into the inlet-trough.

In order to fill silos or floor drying plants the upperconveyor length is fitted with outlets in any quantity needed.
The opening and closing mechanism of the outlets is controlled byremote control i.e. a wire pull.
The outlet hoppers are fitted with a $k square flange, which willfit any of our standard accessories.

HP 1440 r.p.m. 5.5 7.5 10.0
Total length of chain up to 30 m 30 - 50 m 50 - 75 m

 


Send inquiry form
Herbst Group home page
Herbst farm centre

This page was last updated on the 1st ofOctober 1996 .
If you have any questions or suggestions concerning these pagessend an email to marco@herbstgroup.com

- | - | - | - | - | - | - | - | - | - | - | - | - | - | - | - | - | - | - | - |